Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Gladeview, FL

Opener Gear & Sprocket Replacement in Gladeview, FL

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Garage doors rarely fail at a convenient time. If you need opener gear & sprocket replacement in Gladeview, FL, we can often come out the same day when a technician is available. Stripped drive gears replaced so the motor moves the door again.

Signs you need opener gear & sprocket replacement

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Why this happens

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

Before the technician arrives

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

How much does opener gear & sprocket replacement cost?

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local opener gear & sprocket replacement for Gladeview, FL

A closed garage in a Florida summer gets very hot, which shortens the life of opener circuit boards, capacitors and photo-eye sensors. Storms add power surges, so a surge protector is cheap insurance.

Besides Gladeview (ZIP codes 33142, 33147 and 33151), we handle opener gear & sprocket replacement in West Little River (1.2 mi), Brownsville (1.3 mi), Allapattah (1.9 mi) and Pinewood (2.4 mi). Call (833) 435-8883 to book a visit in Gladeview.

Opener Gear & Sprocket Replacement: frequently asked questions

How much does opener gear & sprocket replacement cost in Gladeview, FL?

Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Florida or Gladeview requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Gladeview, FL

Garage Door Tune-Up & Maintenance

A full inspection, lubrication and adjustment to prevent breakdowns.

Typical $90-$200

Genie Opener Circuit Board Replacement

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $175-$400

Cornell Cookson Commercial Door Operator Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $300-$1,200

Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Raynor Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Allstar Remote & Keypad Programming

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $50-$150

Garaga Torsion Spring Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $200-$450

Wood Garage Door Repair

Rotted, warped or split wood sections repaired, sealed and rebalanced.

Typical $200-$700

Insulated Garage Door Installation

Polystyrene and polyurethane insulated doors that cut noise and temperature swings.

Typical $1,500-$5,000

Windsor Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Richards-Wilcox Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Overhead Door Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Gladeview, FL now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote